Split Set Mining Systems

Author: GE

Dec. 09, 2024

Split Set Mining Systems

Split Set Mining Systems, manufacture, distribute and support the original IR Split Set Friction Rock Stabilisers and a complete range of ground support products, including Resin Bolts, Bearing Plates, Cable Bolts, Mine Mesh and Core Storage Systems.

With competitive price and timely delivery, TRM sincerely hope to be your supplier and partner.

Since the introduction of the IR Split Set Stabiliser in , many millions have been used in over 50 countries on seven continents around the world.

Split Set Mining Systems offers ongoing technical support in the way of operator awareness training for the correct installation procedure for ground support products supplied by Split Set Mining Systems.

With branch offices throughout Australia, Split Set Mining is always conveniently placed to service its customers.

mine rock split set bolt

Product Description

Mine rock split set bolt  are rock bolts with only 2 parts, a tube and matching domed bearing plate. The high strength steel tube is slotted along its length. One end is tapered for easy insertion into a drill hole and the other has a welded ring flange to hold the bearing plate.

With the bearing plate in place, the tube is driven into a slightly smaller hole, using the same standard percussion drill that made the hole.       

As the tube of the rock bolt slides into place, the full length of the slot narrows, causing radial pressure to be exerted against the rock over its full contact length.


If you are looking for more details, kindly visit Bolt Pull Test.

DimensionsPhysical PropertiesTechnical DataBolt DiameterA47mm

Yield Strength

Min. 345 Mpa (120KN)Recommended Normal Bit Size41-45mmBolt LengthB0.9-3.0mTypical 445Mpa(150KN)Taper End DiameterC38mm

Tub eUltimate

Tensile

Strength

Min. 470 Mpa (160KN)Typical   Breaking Capacity178KNTaper Slot WideD2mmTypical 530Mpa(180KN)Taper LengthE100mm

Mass pe

Meter

2.71 KgsMin. Breaking Capacity133KNBolt Slot WideF25mmRing LocationG8mm

Cross Section     

Area

345 mm²Recommended Initial Anchorage  6-10 Tons   (53-89 KN)Material GuageH3/3.2mmRing Wire GuageI8mmHole Diameter Range43-45.5mmUltimate Axial StrainTypical 21% (Thk<16mm)Ring Open GapJ6-7mm


12

0

Comments

Please Join Us to post.

0/2000

All Comments ( 0 )

Guest Posts

If you are interested in sending in a Guest Blogger Submission,welcome to write for us!

Your Name: (required)

Your Email: (required)

Subject:

Your Message: (required)